Installation manual. 1. The kit includes the following parts: 1. Remove the upper part of remote controller (Refer to figure 1). Insert a minus screwdriver into the. this operation manual before using the air conditioner. It will tell See also the operation manual included with the indoor unit for details on the. You can read the recommendations in the user guide, the technical guide or the installation guide for DAIKIN BRC1D You’ll find the answers to all your.
|Published (Last):||5 April 2016|
|PDF File Size:||20.21 Mb|
|ePub File Size:||16.25 Mb|
|Price:||Free* [*Free Regsitration Required]|
Set the remote controller before turning the power supply on. The kit includes the following parts: Setting is carried out in the group mode, however, if the mode number inside the parentheses is selected, indoor units can also be set individually. The switch box and wiring for connection are not included.
Remote controller Wood screws Installation manual Wall plugs Machine screws 1. Brc1e52 and P2 do not have polarity. Not displayed if the indoor unit is not equipped with that function. Be careful not to damage the board with the minus screwdriver.
Long life filter Approx. The PC board is mounted in the upper part of the remote controller.
Connect the terminals on top of the upper part of the remote controller P1, P2and the terminals of the indoor unit P1, P2. First begin fitting from the clips at the bottom. During this time the remote controller can not be operated.
If required, you can limit the user action by restricting the number of operable buttons. Refer to figure 8. Refer to the instruction manual for each optional accessory.
BRC1D52 | Daikin
It’s a community-based project which helps to repair anything. This operation is unnecessary when setting by group. NOTE When wiring, run the wiring away from the power supply wiring in order to avoid receiving electric noise external noise. Change setting when ultra-long filter is installed 2 Thermostat sensor in remote controller 3 Spacing time of display time to clean air filter count setting for when the filter sign is not to be displayed 0 15 25 Approx.
Remove the upper part of remote controller Refer to figure 1 Insert a minus screwdriver into the slots 1 in the lower part of the remote controller 2 placesand remove the upper part of the remote controller. Wire the indoor unit 1 Refer to figure 6 NOTE indoor unit 2 lower part of the remote controller 3 upper part of the remote controller 4 wired from the rear 5 wired from the top 6 notch the part for the wiring to pass through with nippers, etc.
Do not make any settings not given in the table. Be careful not distort the shape of the lower part of remote controller by overtightening mounting screws.
Reattach the upper part of the remote controller Be careful not to pinch the wiring when attaching. Do not directly touch the PC board with your hand. Refer to figure 5. bc1d52
Refer to the chapter “Field settings”. Refer to figure 4: Permission level function 6.