Description: This users manual for Altistart 46 soft start motor controllers contains installation, setup, operation, and maintenance instructions. User’s manual ATS46, 9/21/18, English, Spanish, French, pdf MB. Data Bulletin. Cross Reference Guide for ALTISTART® 46 Soft Start Motor. User’s manual UNI-TELWAY ATS VW3G, 12/13/17, English, pdf MB. Programming manual ATS VW3G, 12/13/17, English.
Author: | Mikazshura Fauk |
Country: | Serbia |
Language: | English (Spanish) |
Genre: | Finance |
Published (Last): | 25 July 2018 |
Pages: | 304 |
PDF File Size: | 9.30 Mb |
ePub File Size: | 16.85 Mb |
ISBN: | 119-1-74893-983-6 |
Downloads: | 19878 |
Price: | Free* [*Free Regsitration Required] |
Uploader: | Tygozragore |
Altistart 46 Maintenance Manual |
Connect the cables to the electronic card observing the labelling and connecting the connectors with 2 wires to the card. For more information, please contact S. Starter disrupted by a DC converter 1. SY3CM 18 5 point socked marked J5: Check correspondence between motor and starter.
They are also manufactured and tested at Schneider factory at Pacy Blanchet. Low torque at start tQ0. LCR Current Reading Manuap Locked rotor on permanent rate Locked rotor fault If the current reading in shunted permanent rate is superior to 5 x In during ms, a fault may occur.
Altistart 46 Soft Starters
Altisfart Green wire mark 2: SY3KC Green wire mark 2: Insert all the wires through the centre of the bracket. Cable too long between motor and starter 1.
Assembly size 5 Parts list Part 6: The pump transformer must be removed. The product structure is altistarf to the one of ATS23, that is to say, a control element common to all sizes, and a power element specially designed to each calibre. J 43 Conversion manua, for sizes 4 and 5 6 – Wiring the control cables of thyristors J4 to J9. Frame dimension No wire out of the transformer lower part SY3CM 14 2 clips: Location of screws for connecting the rating card Screw 8 – Reconnect the rating card of the kit.
Outlet order is not important.
Altistart 46 – Documents and Downloads | Schneider Electric
The position of the blue wires is different on an ATS Conversion instructions for size 3 9 – Install the connectors in the locations behind the control module of the Altistart according to the markings.
Fan 2 3 0V 1 8 5W Recommended torque load for screw M4: No wire out of the transformer lower altiistart 2 mm minimum mandatory Outlet order is not important.
A PC software version superior to V1. J 49 Follow the diagram: FrF or 50 or 60 Hz. Replace connectors J13 and J14 from the current transformers on the rating card. The motor is connected to ATS at this time. SY3KC Blue wire mark 3: Synchronisation connectors absent or wrongly positioned.
For wiring J12 and J32 use long cables with connectors so that they can be connected to the plug-in unit furthest to the left of the starter. This conversion can only be performed on products dated later than the following weeks: Their value is calculated to obtain rated current of each coiling for primar y rated altisfart.
Starter not supplied with current on L1-L2-L3. The starter supplies current but the motor does not run.